w-0105ScanSnap iX1300 Enterprise

Fujitsu ScanSnap iX1300 Enterprise error W-0105 Fix

The Fujitsu ScanSnap iX1300 Enterprise error W-0105 is a proactive maintenance reminder indicating that your feed rollers have reached their recommended usage threshold. This is not a critical hardware error, but it is a necessary notification to prevent future paper-feed issues and ensure scan quality.

1 views

Common causes

  • 1Scan count exceeded pre-set maintenance limit.
  • 2Physical wear of the roller rubber grip.
  • 3Residue build-up affecting feed accuracy.
  • 4Failure to reset the counter after a previous kit change.

Solutions

Diagnóstico rápido

W-0105 is an advisory code. The scanner will likely remain functional, but you should address it soon. Check the current scan count in the software settings to confirm how far past the limit you are.

Solución paso a paso

  1. Purchase the original replacement roller kit to avoid compatibility problems.
  2. Replace the rollers carefully by opening the internal compartment.
  3. Reset the counter in the ScanSnap Home application to clear the W-0105 warning.
  4. Validate by running a test scan.

Prevención y mantenimiento

Use genuine Fujitsu parts to guarantee the best scanning performance. Regular cleaning of rollers will prolong their life before the W-0105 alert appears, but they should be replaced when prompted.

Cuándo llamar a un técnico

If the W-0105 warning continues after a successful counter reset, consult with professional support to ensure there isn't a sensor hardware fault.

Ficha técnica del equipo

  • Technology: Duplex scanner with maintenance counters.
  • Speed/performance: 30 ppm.
  • Connectivity: USB 3.2, Wi-Fi 2.4/5 GHz.
  • Feed capacity: 20 sheets.
  • Compatible consumable: Roller/Separator kit PA03805-0001.
  • Recommended usage: Office document automation.
  • Official drivers / firmware

Steps to follow

  1. 1

    Buy kit

    Get the original Roller/Separator kit (PA03805-0001).

  2. 2

    Replace

    Follow instructions to install the new rollers.

  3. 3

    Reset counter

    Reset the usage counter via ScanSnap Home software.

Frequently asked questions

W-0105 is a scheduled notification letting you know the feed rollers have reached their estimated end of life.

It doesn't immediately stop the scanner, but failure to replace them will likely cause frequent feed errors.

You must use the official Fujitsu roller/separator kit for your iX1300.

While regular cleaning helps, the counter will eventually reach its limit and require replacement.

Fujitsu ScanSnap iX1300 Enterprise error W-0105 Fix | Vimazdev