unable-to-print-36MFC-J805DW

Brother MFC-J805DW error unable-to-print-36: Fix guide

The Brother MFC-J805DW error unable-to-print-36 indicates a fault in the printhead carriage movement. When users search 'why does my Brother MFC-J805DW show error unable-to-print-36?', it often follows an unexpected halt during printing. This error is usually caused by internal mechanical obstructions or a sensor failure affecting the carriage rails.

2 views

Common causes

  • 1Debris on the carriage rail
  • 2Motor drive failure
  • 3Timing strip sensor defect
  • 4Improper ink tank installation

Solutions

Diagnostic

The error 36 signifies that the printer cannot detect the printhead position. You may observe the printhead stalling at one side of the printer. Verify if any foreign object or scrap paper is blocking the guide rail.

Step-by-step solution

  1. Clean printhead: Initiate cleaning via settings.
  2. Check paper path: Inspect and clear the inner rails.
  3. Reseat ink tanks: Remove and reinsert tanks.
  4. Power reset: Unplug for 10 minutes.

Prevention and maintenance

Clean the carriage path regularly and ensure you use only the recommended paper types. Regular printing prevents gear stiction.

When to call a technician

If the carriage remains locked after manual inspection and reset, there may be internal damage to the timing strip or drive motor.

Technical specifications

  • Technology: Inkjet (INKvestment Tank)
  • Speed: 12 ppm
  • Connectivity: Wi-Fi, USB
  • Input capacity: 150 sheets
  • Compatible consumables: LC3033 / LC3035 ink tanks
  • Recommended use: Small office / Home
  • Official Drivers

Steps to follow

  1. 1

    Clean printhead

    Run the deep cleaning cycle from the control panel.

  2. 2

    Check paper path

    Clear any debris or paper scraps found in the rail.

  3. 3

    Reseat ink tanks

    Remove and securely reinstall the ink tanks.

  4. 4

    Power reset

    Unplug the device for 10 minutes to reset the carriage.

Frequently asked questions

This code indicates a carriage obstruction or internal mechanical failure preventing the printhead from moving.

Yes, it indicates a critical positioning failure that requires immediate attention.

Use genuine LC3033/LC3035 INKvestment tanks for proper function.

Print regularly to keep the mechanics active and the nozzles clear.

Brother MFC-J805DW error unable-to-print-36: Fix guide | Vimazdev