S1-4112Xerox Phaser 3260

How to Fix Error S1-4112 on Xerox Phaser 3260

Error S1-4112 relates to a motor or main controller fault in the Xerox Phaser 3260. This is a system-level error that stops the printer from operating until the fault is addressed, often linked to mechanical blockages or power supply instability.

1 views

Common causes

  • 1Main motor electrical failure or power surge.
  • 2Mechanical obstruction in the paper feed path.
  • 3Controller board firmware malfunction.

Solutions

Hard Reset

  1. Power off the device.
  2. Disconnect the power cord for at least one minute.
  3. Reconnect and power on to clear volatile memory.

Mechanical Check

  1. Inspect the paper path for small debris or torn scraps.
  2. Verify the fuser unit moves freely without resistance.

Steps to follow

  1. 1

    Full power cycle

    Unplug the printer and wait for internal capacitors to discharge.

  2. 2

    Path inspection

    Clear any jammed paper scraps from the rear and front trays.

  3. 3

    Test run

    Power up the printer to check if the error persists.

Frequently asked questions

Yes, unstable power delivery can trigger internal controller errors. Connect directly to a wall outlet to test.

Not necessarily; a hard reset often resolves it unless a hardware component is physically burnt out.

If the error persists after three attempts, contact Xerox support as it indicates a hardware failure.