ribbon-outB-FV4T Plus

Toshiba B-FV4T Plus error ribbon-out: Solution

The Toshiba B-FV4T Plus error ribbon-out indicates that the printer cannot detect ribbon movement. This happens if the ribbon has run out, snapped, or if the driver is set to transfer mode while using direct thermal labels. Users ask why does ribbon-out error appear on B-FV4T Plus, and usually, adjusting the print mode in software is the solution.

1 views

Common causes

  • 1Empty or broken ribbon.
  • 2Incorrect driver print mode.
  • 3Incorrect installation side.
  • 4Dirty ribbon sensor.

Solutions

Quick Diagnosis

If you print with direct thermal labels, this error means the driver setting is wrong. Change it to 'Direct Thermal' in your driver. If you do use a ribbon, check if it's broken.

Step-by-step Solution

  1. Check ribbon: Open the head and verify the ribbon is intact.
  2. Adjust mode: Match the driver to your material type (Transfer vs. Direct).
  3. Test tension: Remove any slack from the take-up spool.

Prevention and Maintenance

Keep the ribbon clean from dust. Protect the head from adhesive when idle.

When to Call a Technician

If the sensor remains unresponsive even after a successful ribbon load, the internal sensor is likely faulty.

Device Technical Specifications

  • Technology: Thermal Transfer / Direct
  • Resolution: 203 / 300 dpi
  • Connectivity: USB, Ethernet, Serial
  • Compatible supplies: B-FV4T Ribbons
  • Recommended usage: Persistent labels
  • Official drivers / firmware

Steps to follow

  1. 1

    Check ribbon

    Open the head and check if the ribbon is properly installed or empty.

  2. 2

    Adjust mode

    Set the driver to 'Thermal Transfer' if using ribbon.

  3. 3

    Test tension

    Tighten the take-up reel to remove slack from the ribbon.

Frequently asked questions

The printer detects no movement, usually caused by broken ribbon or incorrect print mode settings.

If set to thermal transfer but you have no ribbon, the printer will trigger an error.

Ensure the shiny side is facing the printhead and the dull side faces the labels.

Always ensure your driver settings match your label/ribbon material.

Toshiba B-FV4T Plus error ribbon-out: Solution | Vimazdev