ribbon-endDL3860

Fujitsu DL3860 error ribbon-end: Quick Replacement Guide

The Fujitsu DL3860 error ribbon-end signals that the internal sensor has detected a lack of ink or low tension. Why does my fujitsu dl3860 show ribbon-end? This is usually due to the ribbon reaching the end of its cycle. Replacing the cartridge is the standard fix.

1 views

Common causes

  • 1Ribbon fabric exhaustion.
  • 2Cartridge sensor error.
  • 3Incorrect installation of the ribbon fabric on the head guide.
  • 4Dried ink clogging the feed mechanism.

Solutions

Diagnóstico rápido

If the printout is faint or the message appears on the LCD, the ribbon has exhausted its ink or the sensor is not picking up the tension.

Solución paso a paso

  1. Power off the unit.
  2. Open the top housing.
  3. Release the old cartridge.
  4. Snap in a new one.
  5. Tighten the tension knob.

Prevención y mantenimiento

Only use genuine ribbons to keep the print head clean. Avoid generic brands that may leave loose debris.

Cuándo llamar a un técnico

If the message persists after replacement, the ribbon sensor may require adjustment.

Ficha técnica del equipo

  • Technology: 24-pin Impact
  • Speed: 480 cps
  • Connectivity: Serial/USB
  • Consumible: DL3800 Ribbon Cartridge
  • Usage: High volume document printing
  • Drivers / firmware official

Steps to follow

  1. 1

    Open lid

    Access the ribbon compartment.

  2. 2

    Remove cartridge

    Press the tabs to release the old cartridge.

  3. 3

    Install new ribbon

    Insert the new cartridge and ensure tension.

  4. 4

    Verify

    Rotate the tension knob.

Frequently asked questions

The printer detects the end of the ribbon or low tension in the cartridge feed.

Yes, avoid printing with a dry ribbon to prevent physical damage to the print pins and platen.

Only use high-quality original DL series nylon ribbons for optimal performance.

Replace the ribbon as soon as the print quality fades to prevent mechanical stress.