paper-jam-rearHL-L8260CDW

Brother HL-L8260CDW Paper Jam Rear: Troubleshooting

The Brother HL-L8260CDW error Paper Jam Rear is a notice indicating a paper jam specifically in the rear section of the printer, right in the fuser area. This fault is common when printing on envelopes or heavy paper without having correctly configured the output path. It is imperative to handle this situation calmly to avoid damaging the output rollers. Brother designs these printers with intuitive rear access to facilitate these quick maintenance tasks.

1 views

Common causes

  • 1Use of non-recommended paper (too thick or sticky).
  • 2Rear output tray closed during special printing.
  • 3Accumulation of dirt on the output rollers.
  • 4Poorly aligned paper in the main input tray.

Solutions

Diagnóstico rápido

The error appears on the touch screen or control panel. If you hear a sound of paper hitting a barrier, check the rear door immediately before trying to print again.

Solución paso a paso

  1. Open rear cover: Open the rear tray cover located at the back of the device.
  2. Release levers: Push the green levers on both sides of the fuser to open the output area.
  3. Extract paper: Pull the jammed paper using both hands with a steady, even motion.
  4. Close system: Close the green levers and the cover so the device restarts automatically.

Prevención y mantenimiento

If you print envelopes or heavy paper regularly, keep the rear door open. Periodically clean the output rollers to prevent them from accumulating adhesive residue.

Cuándo llamar a un técnico

If you open the rear door and notice that the fuser has stuck burned paper residue, a technician is required for a deep cleaning or fuser sheet replacement.

Ficha técnica del equipo

  • Tecnología: Color Laser
  • Velocidad/rendimiento aproximado: 31 ppm
  • Conectividad: Gigabit Ethernet, Wi-Fi, USB
  • Capacidad de alimentación: 250 sheets standard
  • Consumible compatible: TN-431 / TN-433 cartridges
  • Uso recomendado: Departmental offices
  • Official drivers / firmware

Steps to follow

  1. 1

    Open rear cover

    Open the rear tray cover located at the back of the device.

  2. 2

    Release levers

    Push the green levers on both sides of the fuser to open the output area.

  3. 3

    Extract paper

    Pull the jammed paper using both hands with a steady, even motion.

  4. 4

    Close system

    Close the green levers and the cover so the device restarts automatically.

Frequently asked questions

This error occurs because a sheet of paper has become stuck while exiting through the fuser in the rear.

If you pull too quickly or at an angle, the paper can tear; always use both hands gently.

While it's a paper error, make sure the fuser is in good condition and free of sticky residue.

Ensure the rear output tray is open if you are using envelopes or heavy paper.