p08PIXMA TS3300

Canon PIXMA TS3300 error P08: Ink Absorber

The Canon PIXMA TS3300 error P08 signifies that the waste ink absorber counter is approaching its limit. Each time the printer performs a cleaning cycle, it pumps excess ink into internal pads, which have a finite capacity. This is a preventive error to avoid ink spills within the chassis. To resolve P08, a software reset is required, and eventually, a physical component replacement. This model is ideal for domestic users with moderate printing needs.

0 views

Common causes

  • 1Residual ink counter reaching pre-defined limit.
  • 2Excessive use of printhead cleaning cycles.
  • 3Natural wear of absorbent material.
  • 4Firmware error calculation of system ink waste.

Solutions

Diagnóstico rápido

The P08 error is usually the precursor to a complete machine lockout. If your printer has years of intensive use, it is almost certain the counter has reached its factory operational limit.

Solución paso a paso

  1. Disconnect the printer from power and wait a few minutes.
  2. Power it back on; if the P08 persists, the lockout is hard-coded in the internal counter.
  3. Consult a technician about resetting the EEPROM memory counter.
  4. Schedule a physical replacement of the pads if the counter has already been reset previously.

Prevención y mantenimiento

Do not perform unnecessary printhead cleanings, as each cycle fills the absorber pads gradually. Use the printer regularly to prevent printheads from drying out, which requires intensive cleaning cycles.

Cuándo llamar a un técnico

This error is not permanently fixed by software alone; once reset, it is vital that a technician replaces the saturated pads before the ink reaches the main logic board.

Ficha técnica del equipo

  • Technology: Inkjet printer.
  • Speed/approx performance: 7.7 ipm (black).
  • Connectivity: Wi-Fi and USB.
  • Power supply: 60-sheet rear tray.
  • Compatible consumables: PG-545 and CL-546 cartridges.
  • Recommended use: Low-frequency home printing.
  • Official drivers / firmware

Steps to follow

  1. 1

    Check counter

    Confirm the error is P08 via the status monitor.

  2. 2

    Power cycle

    Unplug the printer for a few minutes to clear any temporary lock.

  3. 3

    Technical service

    If the error returns, the absorber must be replaced professionally.

Frequently asked questions

It indicates that the residual ink counter has reached nearly its maximum capacity.

The machine will lock up preventively to avoid ink leakage.

PG-545 and CL-546; the error relates to waste, not toner.

Perform printhead cleanings only when absolutely necessary.