p07PIXMA MG2522

Canon PIXMA MG2522 Error P07: Quick Troubleshooting Guide

The Canon PIXMA MG2522 error P07 indicates that the internal waste ink absorber has reached its capacity limit. This code appears when the printer software determines that the cleaning sponge is saturated after numerous ink purges. To clear this error, you must access service mode and reset the internal counter. This ink jet printer is designed for light office use, and this maintenance step is essential for continuous operation.

1 views

Common causes

  • 1Internal counter reached after many automated ink purges.
  • 2Physical saturation of the internal waste ink sponge.
  • 3Logic board inconsistency regarding the pad status.
  • 4Excessive use of automated cleaning cycles.

Solutions

Diagnóstico rápido

The P07 error is identified by alternating orange and green lights on the printer panel. Ensure this isn't a simple paper jam before proceeding. If your computer displays the P07 warning, the printer has effectively reached its factory-set service limit.

Solución paso a paso

  1. Disconnect the power cord from the printer.
  2. Hold the Stop button and connect the power cable.
  3. Hold both buttons down, then release the Stop button.
  4. Press the Stop button exactly five times.
  5. Release the Power button and confirm the LED turns steady green.

Prevención y mantenimiento

Avoid frequent deep cleanings from your computer as these use significant ink and accelerate waste pad filling. Keep the device in a clean environment to prevent dust from interfering with internal sensors. Using original cartridges is advised to maintain consistent ink output and avoid sensor errors.

Cuándo llamar a un técnico

If the reset procedure fails or if you notice visible ink leaking from the bottom of the device, you should contact a professional service center immediately.

Ficha técnica del equipo

  • Technology: FINE Inkjet
  • Speed/Performance: 8 ipm black / 4 ipm color
  • Connectivity: High-speed USB 2.0
  • Feeding Capacity: 60-sheet rear tray
  • Compatible Consumables: PG-245/CL-246 series
  • Recommended Use: Home / Casual
  • Official Drivers / Firmware

Steps to follow

  1. 1

    Power off

    Disconnect the power cable while holding the power button.

  2. 2

    Enter Service Mode

    Reconnect power while holding Stop, then press Power.

  3. 3

    Reset counter

    Release Stop and press it five times to reset the internal counter.

Frequently asked questions

The P07 error means the waste ink pad is full. It's a safety counter triggered when the printer has performed many cleaning cycles.

It is a maintenance alert. You can reset it, but the physical pad remains saturated and may eventually leak.

The MG2522 uses PG-245 black and CL-246 color FINE cartridges.

Perform head cleanings only when print quality degrades to avoid premature waste ink pad saturation.