p07PIXMA G1220

Error P07 Canon PIXMA G1220: Ink Counter Fix

The Canon PIXMA G1220 error P07 is a warning that the ink absorber pads have reached their theoretical capacity. This code is common in high-usage printers and prevents printing to avoid leaks. Follow these steps to reset the counter.

1 views

Common causes

  • 1Internal ink counter reaching threshold.
  • 2Frequent deep cleaning cycles.
  • 3Absorber pad physical saturation.
  • 4Firmware logic lock.

Solutions

Quick Diagnosis

Error P07 manifests as flashing orange and green lights. It is a logical lock caused by the internal accounting system reaching its limit.

Step-by-Step Solution

  1. Enter service mode by holding Stop while the device is on.
  2. While holding Stop, press Power, then release Stop.
  3. Press Stop 5 times, then release Power.
  4. The light will stabilize, confirming the reset.

Prevention and Maintenance

If your printer sees heavy use, keep the base area clean. Replacement of the physical pads is recommended after a few resets to prevent internal damage.

When to Call a Technician

If ink is visible dripping from the base after resetting, take it to service immediately to prevent a permanent short circuit of the logic board.

Equipment Data Sheet

  • Technology: Refillable Ink Tank
  • Speed: Up to 9.1 ipm (B&W)
  • Connectivity: High-speed USB
  • Feed Capacity: 100 sheets
  • Compatible Consumables: GI-11 bottles
  • Recommended Use: Home/Student
  • Official Drivers / Firmware

Steps to follow

  1. 1

    Service mode

    Enter service mode by holding the Stop button while turning on.

  2. 2

    Reset counter

    Press the Stop button multiple times to select the ink counter reset.

  3. 3

    Reboot

    Turn the printer off and on to apply changes.

Frequently asked questions

Error P07 indicates the internal ink absorber counter has reached its maximum limit.

Yes, as the counter is an estimate; if they are fully saturated, they may start leaking.

Always use original Canon GI-11 ink bottles to ensure optimal print head health.

Yes, the printer locks to prevent potential ink spills inside the chassis.