P05M7100DN

Pantum M7100DN error P05: Paper Jam Troubleshooting

The Pantum M7100DN error P05 indicates a paper jam in the output area. Users often ask why does Pantum M7100DN show error P05, usually caused by misaligned paper trays. Follow this guide to clear the error P05 on M7100DN.

1 views

Common causes

  • 1Paper misaligned in tray.
  • 2Output sensor clogged with paper dust.
  • 3Worn exit rollers.
  • 4Unsupported paper weight.

Solutions

Diagnóstico rápido

The error P05 triggers if paper fails to exit. Check the rear door.

Solución paso a paso

  1. Open rear door: Access the fuser unit.
  2. Remove paper: Gently pull the stuck page.
  3. Close and reset: The printer should auto-restart.

Prevención y mantenimiento

Use clean, dry paper. Clean the pick rollers quarterly.

Cuándo llamar a un técnico

If the error P05 shows without a jam, the exit sensor may be failed.

Ficha técnica del equipo

  • Technology: Mono Laser
  • Speed: 33 ppm
  • Connectivity: USB, Ethernet, Wi-Fi
  • Capacity: 250 sheets
  • Supplies: TL-410 series
  • Recommended use: Small office
  • Drivers / official firmware

Steps to follow

  1. 1

    Open rear door

    Access the fuser unit.

  2. 2

    Remove paper

    Gently pull the stuck page.

  3. 3

    Close and reset

    Auto-restart the unit.

Frequently asked questions

Paper jam in the exit area.

Yes, pull gently.

TL-410 series.

Use quality paper.