p008MAXIFY iB4120

Canon MAXIFY iB4120 error P008: Paper Feed Fix

The Canon MAXIFY iB4120 error P008 indicates a failure in the main paper feed system. When the feed motor cannot move the sheet into the interior, the machine stops to prevent a larger jam, answering why is my Canon MAXIFY iB4120 showing error P008?. Periodic roller cleaning is the most effective way to prevent this technical warning.

1 views

Common causes

  • 1Dirty feed rollers that have lost adhesion.
  • 2Low-weight or textured paper sliding on the rollers.
  • 3Misaligned paper load activating the jam sensor.
  • 4Paper presence detection sensor failure.

Solutions

Diagnóstico rápido

If you observe the motor trying to spin but the paper does not move, the issue is poor traction on the rollers or an incorrect tray load.

Solución paso a paso

  1. Remove paper from the tray and check for folded sheets or residue.
  2. Clean feed rollers with a slightly damp cloth to restore traction.
  3. Adjust paper guides to the exact sheet size before reinserting the tray.

Prevención y mantenimiento

Clean rollers periodically every 10,000 prints to remove paper dust. Avoid overfilling the tray beyond the maximum capacity marked by the internal indicator.

Cuándo llamar a un técnico

If the error P008 persists after cleaning the rollers and testing with fresh paper, the feed motor or paper presence sensor likely needs replacement.

Ficha técnica del equipo

  • Technology: Inkjet printer
  • Speed: Up to 32 ppm
  • Connectivity: USB, network, WiFi
  • Compatible Consumables: PGI-2200 Series
  • Recommended Use: Small office
  • Official Drivers / Firmware

Steps to follow

  1. 1

    Paper Check

    Remove paper from the tray and check for folded sheets or residue.

  2. 2

    Roller Cleaning

    Clean feed rollers with a slightly damp cloth to restore traction.

  3. 3

    Alignment

    Adjust paper guides to the exact sheet size before reinserting the tray.

Frequently asked questions

The P008 code indicates that the tray feed motor is not catching paper or the detection sensor is blocked.

It is not critical, but ignoring it can lead to constant jams that will eventually damage the feed rollers.

Standard 80g bond paper is recommended; paper that is too thick or textured might trigger this sensor.

We recommend doing so every 10,000 prints or whenever you notice the printer is struggling to take paper.

Canon MAXIFY iB4120 error P008: Paper Feed Fix | Vimazdev