Network 001FS-4100DN

Kyocera FS-4100DN Network Error 001: Connectivity Fix

Network errors on the Kyocera FS-4100DN prevent the unit from communicating with the print server or local workstations. This issue usually stems from incorrect TCP/IP settings or physical link failures. Following systematic diagnostic steps can restore connectivity quickly.

1 views

Common causes

  • 1IP address conflict with existing network devices.
  • 2Bad cabling or poor connection to the network switch.
  • 3Misconfigured Gateway settings preventing communication with external subnets.

Solutions

Physical Cable Check

  1. Inspect the Ethernet cable for physical wear.
  2. Ensure the link LEDs on the network port are blinking.
  3. Try swapping the patch cable with a known working one.

TCP/IP Configuration

  1. Navigate to the network settings in the control panel.
  2. Verify the IP address, Subnet Mask, and Default Gateway.
  3. Confirm that the network mode is set correctly to your environment (Static vs DHCP).

Steps to follow

  1. 1

    Print network report

    Print the network status report from the printer menu to verify current settings.

  2. 2

    Web interface test

    Access the Command Center RX web portal using the printer's IP address.

  3. 3

    Network reset

    Clear existing network settings via the panel and restart the printer.

Frequently asked questions

This can happen if the printer is on DHCP and the router reassigns its IP address frequently.

For corporate office environments, static IP is highly recommended to ensure consistent communication.

It is the web-based utility for managing Kyocera printers remotely via any browser.