j-0001TASKalfa 1802i

Error J-0001 Kyocera TASKalfa 1802i: Jam Guide

The Kyocera TASKalfa 1802i error j-0001 is a paper jam warning in the Tray 1 feed area. This issue often recurs if paper is loaded incorrectly or rollers are dusty. To solve the j-0001 error on the TASKalfa 1802i, remove all paper scraps and realign the stack.

1 views

Common causes

  • 1Improper paper alignment in input tray.
  • 2Dirty pickup rollers with excess paper dust.
  • 3High humidity in paper causing clumping.
  • 4Blocked or dirty tray passage sensor.

Solutions

Diagnóstico rápido

The J-0001 is triggered by the passage sensor in the main tray. If you see the paper wrinkled at the tip, the problem is traction.

Solución paso a paso

  1. Remove paper: Pull out the tray and clear the jammed sheets carefully.
  2. Check inside: Open the side door to look for hidden paper scraps that the sensor may still be detecting.
  3. Reset: Close all covers; the machine will automatically detect the correct loading.

Prevención y mantenimiento

Fan the paper well before loading. Do not exceed the maximum tray capacity. Use original TK-4105 toner to prevent internal dust.

Cuándo llamar a un técnico

If the message persists after cleaning the sensor and path, the passage sensor may be mechanically damaged.

Ficha técnica del equipo

  • Technology: Monochrome laser
  • Print Speed: 18 ppm
  • Connectivity: USB 2.0
  • Paper Capacity: 400 sheets
  • Compatible Consumable: TK-4105
  • Recommended Use: Small office
  • Official drivers / firmware

Steps to follow

  1. 1

    Remove paper

    Pull out the tray and clear the jammed sheets.

  2. 2

    Check inside

    Open the side door to find hidden paper scraps.

  3. 3

    Reset

    Close all covers and the unit will auto-detect readiness.

Frequently asked questions

The J-0001 is the standard code for a paper jam located right at the tray 1 entrance.

Always pull in the paper's normal flow direction to avoid tearing it inside the rollers.

Only genuine TK-4105 is supported; low-quality generic toner can dirty paper sensors.

Make sure to fan the paper before loading and do not exceed tray capacity limits.

Error J-0001 Kyocera TASKalfa 1802i: Jam Guide | Vimazdev