i-0050ScanSnap iX1700 Deluxe

Fujitsu ScanSnap iX1700 Deluxe Error I-0050: Maintenance

Fujitsu ScanSnap iX1700 Deluxe error I-0050 is a preventive maintenance reminder. It indicates that the feed rollers have reached the end of their design life. What to do when I-0050 error appears? Clean or replace the rollers and reset the counter in the software.

1 views

Common causes

  • 1Roller counter reached limit (100k cycles).
  • 2Physical degradation of roller rubber.
  • 3Excessive paper dust accumulation.
  • 4Improper cleaning solvents used.

Solutions

Diagnóstico rápido

The I-0050 is an informational advisory. Check your rollers for wear to decide if replacement or just cleaning is necessary.

Solución paso a paso

  1. Inspect consumables: Check the condition of the main feed rollers.
  2. Replace kit: Install a new FI-CX1700KIT if rollers are worn.
  3. Access software: Launch ScanSnap Home on your computer.
  4. Reset counter: Navigate to Settings > Consumables and reset the counter.

Prevención y mantenimiento

Clean rollers monthly. Do not wait for the I-0050 code. Clean rollers prevent paper slipping and extend the life of the entire feed assembly.

Cuándo llamar a un técnico

If mechanical errors occur after the reset and kit replacement, the internal drive motor may be failing.

Ficha técnica del equipo

  • Technology: High-speed scanner
  • Performance: 40 ppm
  • Connectivity: Wi-Fi / USB
  • Feed: 80-sheet ADF
  • Consumables: Roller Kit FI-CX1700KIT
  • Usage: Professional office
  • Official drivers / firmware

Steps to follow

  1. 1

    Inspect consumables

    Check the condition of the main feed rollers.

  2. 2

    Replace kit

    Install a new FI-CX1700KIT if rollers are worn out.

  3. 3

    Access software

    Launch ScanSnap Home on your computer.

  4. 4

    Reset counter

    Navigate to Settings > Consumables and reset the counter.

Frequently asked questions

The I-0050 is a preventive notification that the roller feed counter has reached its recommended service limit.

It won't stop scanning, but neglecting it leads to increased paper jams.

You need the FI-CX1700KIT roller kit (Pad and Pick Roller).

Perform deep cleaning every 5,000 scans and replace the kit when this code appears.

Fujitsu ScanSnap iX1700 Deluxe Error I-0050: Maintenance | Vimazdev