f248ECOSYS M8130cidn

Kyocera ECOSYS M8130cidn error F248: Network Failure

The Kyocera ECOSYS M8130cidn error F248 is a network interface communication error. It signifies a potential fault in the internal NIC (Network Interface Card) or a bad handshake with the local gateway.

0 views

Common causes

  • 1Network IP address conflict.
  • 2Defective internal NIC.
  • 3Incompatible router protocols.
  • 4Bad ethernet cable.

Solutions

Diagnóstico rápido

If the printer boots up fine without the LAN cable connected, the issue is likely a network conflict or a faulty network switch port.

Solución paso a paso

  1. Disconnect: Unplug the LAN cable.
  2. Cold Boot: Power cycle the printer.
  3. Network Test: Reconnect in a different switch port.

Prevención y mantenimiento

Use a surge protector and verify your network switch settings.

Cuándo llamar a un técnico

If the error persists without any cable attached, the internal networking module requires hardware replacement.

Ficha técnica del equipo

Steps to follow

  1. 1

    Disconnect

    Unplug the LAN cable.

  2. 2

    Cold Boot

    Power cycle the printer.

  3. 3

    Network Test

    Reconnect in a different switch port.

Frequently asked questions

Isolate the printer from the network and retest. Replace cabling if needed.

Yes, if the fault is strictly network-related.

TK-8115 series.

Assign a static IP to the device.