F050FS-1370DN

Fix Kyocera FS-1370DN F050 Memory Error

The F050 error code on the Kyocera FS-1370DN refers to a memory communication error or a firmware failure during the boot process. This message prevents the printer from initializing correctly due to corrupted data reading or a faulty RAM module. The recommended first step is to perform a hard system reset or attempt a firmware update via the device's web interface.

1 views

Common causes

  • 1Firmware corruption: The internal boot data has lost integrity.
  • 2Buffer saturation: A print job exceeds available physical RAM.
  • 3RAM failure: The memory module has bad sectors.
  • 4Incompatible drivers: Obsolete drivers sending invalid commands to the print engine.

Solutions

Quick Diagnosis

The F050 error usually appears right after turning on the printer, locking the control panel. If it appears intermittently when sending complex documents, it often means the print cache is full or the print file contains incompatible instructions that the firmware cannot process.

Step-by-Step Solution

  1. Power cycle: Turn off the printer, unplug the network/USB cable, and then turn it back on.
  2. Boot test: If it boots successfully without cables, the issue is caused by a print job sent from the computer.
  3. Clear print queue: Cancel all pending print jobs on your computer before reconnecting the network cable.
  4. Update: Log into the printer's web configuration page to check for and install the latest firmware updates.

Prevention and Maintenance

Keep your printer drivers updated on all office workstations. Avoid sending excessively large PDF files (over 100MB) in one batch, as this overwhelms the FS-1370DN's internal memory. Restart the machine weekly to flush the process cache.

When to Call a Technician

If the F050 error occurs even when disconnected from the network and after a firmware update attempt, the mainboard or integrated RAM module likely has a physical defect. In this case, professional hardware repair is required.

Ficha técnica del equipo

  • Technology: Monochrome Laser
  • Standard Memory: 128 MB (expandable)
  • Processor: PowerPC 440/500 MHz
  • Emulations: PCL6, KPDL3, Line Printer
  • Consumable: TK-170 series toner
  • Usage: Shared office environments
  • Official Drivers / Firmware

Steps to follow

  1. 1

    Isolate from network

    Unplug network cables to isolate the device from external print commands.

  2. 2

    Clear queue

    Delete all pending documents from the OS print queue.

  3. 3

    Reset network

    Reconnect the printer and ensure it has a static IP address to avoid conflicts.

  4. 4

    Firmware update

    Apply the latest official firmware to stabilize memory management.

Frequently asked questions

Not necessarily. It is typically a software-related memory error that can be resolved via firmware updates or print job management.

Yes, because the F050 error puts the printer in a 'locked' state, rendering it useless until the memory is reset.

This model uses the TK-170 toner series. Using original consumables ensures that internal sensors communicate correctly with the printer's logic.

Avoid sending overly large documents and keep the firmware updated through the web administration page.