error-drum-endDCP-L2620DW

Brother DCP-L2620DW error drum end: Reset guide

The Brother DCP-L2620DW error drum end alert indicates that the drum unit has reached its pre-programmed page limit. While the printer may continue to print for a short time, replacing the unit is necessary to ensure consistent print quality.

1 views

Common causes

  • 1Drum unit cycle expired
  • 2Excessive toner dust
  • 3Faulty drum sensor

Solutions

Quick Diagnosis

The error appears on the LCD panel. Check if your print output has streaks or background spots, which confirms the drum is worn.

Step-by-step Solution

  1. Turn off the printer.
  2. Open the front cover and remove the drum/toner assembly.
  3. Release the toner cartridge from the drum.
  4. Insert the new DR2510 drum.
  5. Reset the drum counter in the settings menu.

Prevention and Maintenance

Slide the green tab on the drum unit back and forth periodically to clean the corona wire.

When to call a technician

If the machine continues to report the error after reset, the drum sensor may be faulty.

Device technical specs

  • Technology: Monochrome Laser
  • Compatible Consumables: Toner TN2510, Drum DR2510
  • Connectivity: Wi-Fi, USB
  • Official Drivers

Steps to follow

  1. 1

    Access drum unit

    Open the front cover and pull out the drum and toner assembly.

  2. 2

    Reset counter

    Follow the on-screen menu instructions to confirm you have replaced the drum unit.

Frequently asked questions

Navigate to the settings menu, select machine info, and confirm the replacement of the drum unit after installing a new one.

It is not advised, as it can reduce quality and potentially cause internal damage.

The printer uses the DR2510 drum unit.

Use the built-in corona wire slider on the drum unit.