err-4005ZC300t

Zebra ZC300t error 4005: Card feed troubleshooting

Zebra ZC300t error 4005 is a clear sign that the printer's card feeder sensor is not detecting the entry of a card. This often occurs due to a card jam or roller obstruction that prevents the card from entering the transport path. A quick physical inspection is usually sufficient to clear the fault and resume production.

1 views

Common causes

  • 1Damaged card with rough edges causing a jam.
  • 2Debris buildup on the transport rollers.
  • 3Card thickness mismatch in driver settings.
  • 4Sensor blockage due to dust or lint.

Solutions

Diagnóstico rápido

The 4005 code triggers if the feed sequence starts but the sensor stays inactive. Check the input area for a jammed card; if you see a card partially inside the slot, you have found the cause.

Solución paso a paso

  1. Power off the printer for safety.
  2. Remove the input hopper and check for cards that are stuck.
  3. Gently remove any jams using plastic tools, being careful not to scratch the sensors.
  4. Wipe the rollers with a clean, dry cloth to improve traction.

Prevención y mantenimiento

Only use standard, clean PVC cards (CR-80). Regularly perform the ZC300 cleaning cycle to ensure that the transport rollers remain free of debris.

Cuándo llamar a un técnico

If the feed rollers continue to slip after cleaning, the feed motor assembly might be worn, which will require specialized service intervention.

Ficha técnica del equipo

  • Technology: Dye-sublimation
  • Performance: Up to 200 cards/hr
  • Connectivity: USB 2.0, Ethernet
  • Compatible consumables: ZC300 series ribbons
  • Usage: Identity card printing
  • Firmware / Drivers

Steps to follow

  1. 1

    Empty hopper

    Remove cards from the input hopper.

  2. 2

    Clear jam

    Carefully remove any jammed cards from the print path.

  3. 3

    Restart

    Power cycle the printer via the control panel.

Frequently asked questions

It signals a card feeding failure, likely caused by a jam or roller slippage.

Yes, typically by clearing the card path and ensuring the cards are correctly loaded.

Standard PVC CR-80 cards.

Always keep cards clean and avoid overfilling the input hopper.

Zebra ZC300t error 4005: Card feed troubleshooting | Vimazdev