err-3008ZC300s

Zebra ZC300s error err-3008: Feeder failure

The Zebra ZC300s error err-3008 occurs when the feeder motor fails to correctly move the card into the print head. This error typically indicates a physical obstruction or friction issue in the drive rollers. Clearing any jammed card is essential to avoid damage to the device's precision mechanism.

1 views

Common causes

  • 1PVC cards with static charge sticking together.
  • 2Dirty drive rollers losing traction.
  • 3Physical obstruction from previous card debris.
  • 4Misalignment in the feeder entry guide.

Solutions

Quick Diagnosis

If you see the Zebra ZC300s error err-3008, check if there is a card visibly jammed in the input hopper. This issue is often accompanied by an irregular mechanical noise during the loading attempt.

Step-by-Step Solution

  1. Power off the printer immediately.
  2. Remove the input card cartridge.
  3. Visually inspect the entry path for bent or broken cards.
  4. Remove any debris using soft plastic tweezers.
  5. Power on the unit again to perform a calibration cycle.

Prevention and Maintenance

Clean the drive rollers with an original adhesive cleaning card every 1000 prints. Avoid using low-quality PVC cards with rough edges that damage the mechanism.

When to Call a Technician

If after cleaning the card path and resetting the unit the code persists, the feeder stepper motor may have failed or have worn internal gears.

Device Technical Data

  • Technology: Thermal transfer printing.
  • Resolution: 300 dpi.
  • Feeding: Automatic 100-card hopper.
  • Compatible Consumable: Standard CR-80 PVC cards (0.76mm).
  • Recommended Use: High rotation, retail.
  • Official Drivers / firmware

Steps to follow

  1. 1

    Remove cards

    Remove all cards from the input feeder.

  2. 2

    Check for jams

    Inspect the card path for PVC debris or bent cards.

  3. 3

    Restart

    Turn the unit off and on to reset the input sensor.

Zebra ZC300s error err-3008: Feeder failure | Vimazdev