e4-05fi-7300NX

Fujitsu fi-7300NX E4-05 Error: Image Sensor Failure

The Fujitsu fi-7300NX error E4-05 is a technical alert indicating a problem within the Contact Image Sensor (CIS) unit. This error prevents the scanner from correctly reading the documents, which is commonly triggered by smudges, dust, or glue residues on the exposure glass. If cleaning does not resolve the issue, it may signal a failure in the LED illumination strip. This error is critical for ensuring digital document fidelity, as the machine will stop operations until the image capture system is properly functioning again.

1 views

Common causes

  • 1Dust or toner buildup on the CIS glass.
  • 2Residue from sticky documents or liquid glue.
  • 3Internal LED light bar failure.
  • 4Long-term wear causing optical sensor desensitization.

Solutions

Diagnóstico rápido

If you notice persistent vertical streaks on your scans before the E4-05 code appears, the sensor glass is likely dirty. If the images are entirely black, the issue is likely a faulty internal light source.

Solución paso a paso

  1. Access Sensor: Open the ADF cover to expose the glass strips.
  2. Deep Clean: Use the official cleaning kit to wipe the glass surfaces.
  3. Visual Check: Check if the illumination bar lights up when the scanner is closed and active.
  4. Calibration: Perform the image calibration routine using the scanner software on your PC.

Prevención y mantenimiento

The best way to prevent E4-05 is by using official cleaning sheets regularly. Avoid scanning damaged or sticky documents to protect the internal glass optics.

Cuándo llamar a un técnico

If the error persists after thorough cleaning and calibration, or if the light bar is flickering, contact authorized support for professional CIS module replacement.

Ficha técnica del equipo

  • Technology: Dual CIS (Contact Image Sensor)
  • Optical Resolution: 600 dpi
  • Consumables: Glass cleaning kit
  • Usage: Document management workflow
  • Official drivers / firmware

Steps to follow

  1. 1

    Open ADF Unit

    Unlock the cover to access the optical sensor glass area.

  2. 2

    Clean Glass Surfaces

    Use a lint-free cloth and lens cleaner to remove smudges from the glass.

  3. 3

    Check LED

    Confirm the internal light source turns on when the scanner is powered.

  4. 4

    Calibrate

    Run the calibration utility from your PC scanner software.

Frequently asked questions

The E4-05 error indicates an image sensor mismatch, often caused by dust on the glass or LED light failure.

While rare, internal sensor failure is possible. Most issues are resolved through proper cleaning.

Regular use of cleaning sheets for the sensor area is essential for high-quality, error-free images.

Clean it whenever you notice vertical lines or after scanning large batches of dusty documents.