e3001zc350t

Error E3001 Zebra ZC350t: Card Feed Failure

The Zebra ZC350t error E3001 is a card feed warning. This code triggers when the sensor fails to detect card movement, often caused by static-clung cards or dirty rollers. Follow this guide to clean your device and resume printing.

1 views

Common causes

  • 1Static electricity causing card adhesion.
  • 2Dirty or dusty feed rollers.
  • 3Deformed cards (not CR-80).
  • 4Foreign objects blocking sensors.

Solutions

Quick Diagnosis

If the motor runs but the card doesn't feed, check the input hopper for misaligned or stuck cards.

Step-by-Step Solution

  1. Remove the card cartridge and align the stack.
  2. Open the top cover and remove jams.
  3. Use a cleaning kit to wipe rollers.
  4. Close and restart.

Prevention and Maintenance

Regularly clean transport rollers with isopropyl alcohol or cleaning cards. Keep cards free of grease.

When to Call a Technician

If the motor keeps failing after manual cleaning, the feed roller assembly may need replacement.

Equipment Data Sheet

  • Technology: Dye-sublimation
  • Speed: Up to 225 cards/hour
  • Connectivity: USB, Ethernet, Wi-Fi
  • Feed Capacity: 100 cards
  • Compatible Consumables: Zebra YMCKO ribbons
  • Recommended Use: Enterprise ID
  • Official Drivers / Firmware

Steps to follow

  1. 1

    Open cover

    Open the top cover to access the card path.

  2. 2

    Remove card

    Gently remove any jammed cards without damaging rollers.

  3. 3

    Clean rollers

    Use the official cleaning kit for transport rollers.

Frequently asked questions

Error E3001 indicates a feeder problem, often due to stuck cards or debris on rollers.

Use standard CR-80 cards. Low quality cards can leave residue and cause jams.

It occurs frequently if maintenance cleaning is skipped after ribbon changes.

Use original Zebra cleaning kits to ensure the rubber rollers aren't damaged.