e010-0000imageRUNNER 2206N

Canon imageRUNNER 2206N E010-0000 Error: Main Motor

The Canon imageRUNNER 2206N error E010-0000 points to a failure in the main drive motor. This occurs when the speed sensor does not register the motor's correct movement, indicating a mechanical blockage or electrical disconnection. If the motor attempts to spin and stops, the cause usually lies in the gear train or insufficient power from the source.

1 views

Common causes

  • 1Mechanical failure: Gears jammed by dirt or worn parts.
  • 2Main motor: Power loss or damaged coils in the DC motor.
  • 3Connection failure: Motor cable loose on the control board.
  • 4Transfer roller: Blockage of the main roller preventing rotation.

Solutions

Quick Diagnosis

If you hear a short buzz upon startup followed by E010-0000, the motor is struggling to spin against resistance. Check if the feed rollers spin freely by hand (when powered off) to rule out physical jams.

Step-by-Step Solution

  1. Disconnect the power cable and open the side panels.
  2. Turn the feed rollers by hand to verify no obstructions.
  3. Check the main motor cable for any visible damage.
  4. After inspection, power on the device to initiate a new startup sequence.

Prevention and Maintenance

Perform internal gear cleaning to remove paper and toner dust buildup that increases friction. Avoid using cheap recycled toners that leave sticky residue.

When to Call a Technician

E010 often requires partial disassembly of the side gears for deep lubrication or motor replacement if the bearings are worn.

Device Technical Specifications

  • Technology: Laser printing
  • Motor: Brushless DC Motor
  • Consumables: Canon NPG-59
  • Connectivity: LAN/USB
  • Recommended Use: Office environment
  • Drivers / official firmware

Steps to follow

  1. 1

    Visual Inspection

    Open side panels to look for obstructions preventing roller rotation.

  2. 2

    Check Connections

    Ensure the main motor power cable is firmly seated.

  3. 3

    Restart

    Power off and on so the motor can attempt its initial rotation cycle.

Frequently asked questions

The E010 indicates that the main motor fails to reach expected rotation speed or is jammed.

Yes, it often occurs due to lack of lubrication on gears or internal paper jams.

No, the device locks itself to prevent irreparable damage to the motor gears.

Professional servicing should be done according to the service cycle, usually annually.