e006ADS-1200

Brother ADS-1200 error E006: Troubleshooting Guide

The Brother ADS-1200 error E006 indicates a failure in the paper separation mechanism. This alert triggers when sensors detect that the rollers are failing to grip documents correctly, halting the scanning process. Solving the E006 error on Brother scanners is typically a matter of performing a manual cleaning of the feed rollers.

0 views

Common causes

  • 1Dust buildup on the roller surface reducing grip.
  • 2Normal material degradation over long periods of use.
  • 3Adhesive residue from stickers on documents.
  • 4Internal sensor blockage due to debris.

Solutions

Quick Diagnosis

Error E006 typically occurs when the scanner attempts to feed a page and fails, often due to sensor obstruction or debris. Check if the feed rollers look clean or if there's any visible paper dust.

Step-by-step Solution

  1. Disconnect the scanner from the power supply.
  2. Open the front cover carefully.
  3. Wipe the separation rollers with a lint-free, soft, damp cloth.
  4. Inspect the area for stuck paper bits or label residue.

Maintenance and Care

Clean the feed rollers monthly using distilled water on a soft cloth. Keep the scanner in a dust-free environment. Using original supplies helps ensure the longevity of the roller rubber.

When to Call a Technician

If the error persists after cleaning and you observe the rollers not spinning properly, a service technician should evaluate the internal motor health.

Device Technical Sheet

  • Technology: Duplex Document Scanner
  • Speed: Up to 25 ppm
  • Connectivity: USB 3.0
  • Capacity: 20-sheet ADF
  • Consumables: Separation roller kit (ADS-1200 series)
  • Usage: Home office
  • Official drivers / firmware

Steps to follow

  1. 1

    Power off

    Unplug the scanner from the power source.

  2. 2

    Access roller

    Open the front cover and locate the separation roller.

  3. 3

    Clean

    Clean the roller using a soft, damp cloth.

Frequently asked questions

Error E006 happens when the paper feed system fails to grab the document due to dirt or worn rollers.

It is a minor error usually fixed by cleaning the internal feed components.

It uses a separation roller kit. Genuine Brother parts are highly recommended.

Clean the feed rollers periodically every 5,000 scans to prevent dust accumulation.

Brother ADS-1200 error E006: Troubleshooting Guide | Vimazdev