e002fi-6671

Fujitsu fi-6671 Scanner error E002 Troubleshooting

The Fujitsu fi-6671 Scanner error E002 is a status message indicating the upper lid is not fully secured. The device will remain unresponsive until the lid sensor confirms a positive closure. If you are asking why is my Fujitsu fi-6671 showing error E002?, the issue is typically a slight misalignment or a small piece of debris preventing a perfect latch.

1 views

Common causes

  • 1Lid misalignment after paper jamming.
  • 2Dust obscuring the optical sensor path.
  • 3Mechanical latch wear.
  • 4Faulty microswitch.

Solutions

Quick Diagnosis

This error is signaled by a blinking light. Try opening and closing the lid firmly. If it feels loose, check the hinge alignment.

Step-by-Step Fix

  1. Open the lid completely.
  2. Examine the latch mechanism for paper scraps or dust.
  3. Close the lid firmly until it clicks into position.
  4. Wipe the sensor contact points with a clean cloth.

Prevention and Maintenance

Handle the lid with care. Perform monthly cleaning of the internal sensors using the official Fujitsu maintenance kit to prevent signal interference.

When to call a technician

If the error persists despite proper closure, the internal microswitch has failed and requires professional repair.

Technical Specifications

  • Technology: Duplex color CCD
  • Performance: Up to 70 ppm / 140 ipm
  • Connectivity: USB 2.0
  • Capacity: 200-sheet ADF
  • Compatible Consumables: Roller Kit for FI-6671 (PA03xxx)
  • Recommended Use: High-volume document scanning
  • Official Drivers / firmware

Steps to follow

  1. 1

    Check cover

    Ensure the scanner lid is properly seated and latched.

  2. 2

    Clean sensors

    Use compressed air to clean around the lid proximity sensors.

  3. 3

    Restart

    Unplug the scanner and restart the scanning software.

Frequently asked questions

This error means the system detects the cover is open, preventing motor operation for safety.

No, for user safety and optical component protection, the scanner remains locked.

Usually no parts are needed unless the lid microswitch is physically broken.

Keep the latch area free of dust and debris buildup.