e002-0000imageclass-x1650i

Error E002-0000 Canon imageCLASS X1650i: Fuser fix

The error E002-0000 of the Canon imageCLASS X1650i is a fuser heating failure. The system detects the unit is not reaching the operating temperature required to properly fix toner to the paper. This error requires professional attention.

0 views

Common causes

  • 1Temperature sensor failure (thermistor).
  • 2Worn thermal resistance.
  • 3Electrical fluctuations.
  • 4Heat roller wear.

Solutions

Quick Diagnosis

E002-0000 is a hardware error where the fuser cannot maintain the correct temperature.

Step-by-Step Solution

  1. Power off: Disconnect to avoid further damage.
  2. Cool down: Wait 30 minutes.
  3. Power on: Try restarting once.
  4. Service: If the code returns, contact technical support.

Prevention and Maintenance

Use an adequate surge protector.

When to Call a Technician

Mandatory call to service to inspect the fuser unit.

Equipment Technical Data

Technology: Laser; Speed: 50 ppm; Connectivity: Gigabit; Capacity: 650 sheets; Consumable: 057; Usage: Office; Drivers: Official Canon support.

Steps to follow

  1. 1

    Shutdown

    Cut electrical supply.

  2. 2

    Cooling

    Wait 30 min.

  3. 3

    Test

    Try power on to verify.

  4. 4

    Technical support

    If persistent, call service.

Frequently asked questions

It indicates the fuser temperature is incorrect; it is below operating levels.

Yes, it is a hardware error that blocks the unit for thermal safety.

Always use original Canon 057 series toner to maintain thermal parameters.

Avoid voltage variations and cleaning with non-recommended paper.