e001fi-7481c

Error E001 Fujitsu fi-7481C: Paper Jam Solution

The Fujitsu fi-7481c error e001 is an interruption notice related to the Automatic Document Feeder (ADF). This code appears when sensors detect that paper is not moving correctly into the scanning path, temporarily locking the device. Below, we explain how to clear the path and check the sensors to resume operation.

0 views

Common causes

  • 1Documents with staples or paper clips causing blockages in the guide.
  • 2Excessive wear of the pickup rollers.
  • 3Accumulation of paper dust on the sheet-presence sensors.
  • 4Very thin or wrinkled documents losing rigidity in the tray.

Solutions

Fast Diagnosis

The E001 error in this Fujitsu model is identified when the unit stops mid-scan during a batch. Listen for motor straining or check the input sensor for small debris, dust, or misaligned sheets.

Step-by-Step Solution

  1. Stop Operation: Press the Stop button on the scanner's front panel.
  2. Visual Inspection: Open the top cover and remove any jammed document.
  3. Quick Cleaning: Pass a soft cloth over the optical sensors and rubber rollers.
  4. Reset: Close the lid and let the equipment perform its initial calibration cycle.

Prevention and Maintenance

Perform roller cleaning at least once a month using original cleaning kits. Ensure a dust-free environment, as debris can settle on sensors and trigger false paper errors.

When to Call a Technician

If the E001 error appears even with an empty tray after sensor and roller cleaning, the sensor may be physically damaged or the drive motors may be experiencing mechanical failure.

Device Technical Sheet

  • Technology: Duplex ADF Scanning
  • Approximate performance: 80 ppm
  • Connectivity: USB 3.0
  • Input capacity: 100 sheets
  • Compatible supply: Roller Set (PA03710-0001)
  • Recommended use: Intensive document digitization
  • Drivers / official firmware

Steps to follow

  1. 1

    Open the Cover

    Press the release button and open the feed cover to inspect the paper path.

  2. 2

    Clear Jam

    Gently remove any document blocking the automatic feeder sensor.

  3. 3

    Clean Rollers

    Wipe the feed rollers with a soft, lint-free cloth lightly dampened with isopropyl alcohol.

Frequently asked questions

The E001 error indicates a paper jam detected by input sensors, often caused by crinkled documents or debris.

Yes, the scanner halts for safety reasons to prevent damage to image sensors and feed rollers.

It requires an original roller set to maintain proper sheet traction and consistent feed.

Regularly clean feed rollers and ensure documents are free of staples or paper clips.