e000imageCLASS MF244dw

Error E000 Canon imageCLASS MF244dw: How to Fix

The Canon imageCLASS MF244dw error E000 points to an irregular thermal state detected by the fuser sensor. Once triggered, the unit locks all tasks to prevent hardware damage. Understanding what is E000 error in Canon MF244dw allows you to identify if the issue is a simple glitch or a major component failure.

1 views

Common causes

  • 1Failing thermistor sensor.
  • 2Torn fuser sleeve caused by paper jams.
  • 3Power fluctuations damaging the motherboard.
  • 4End of life of the fusing unit.

Solutions

Diagnóstico rápido

The E000 error appears as a stop code on the display panel. If it comes with a screeching sound from the rear, it indicates physical resistance in the fuser unit that requires immediate attention.

Solución paso a paso

  1. Power down: Turn off the unit using the power button.
  2. Unplug: Disconnect the power cable from the electrical socket.
  3. Cooldown: Allow 10 minutes for residual heat to dissipate.
  4. Reconnect: Plug into a wall socket (not a surge protector) and turn back on.

Prevención y mantenimiento

Clean the pickup rollers every six months to prevent paper jams that put extra stress on the fuser. Avoid printing on adhesive labels that aren't heat-rated, as they can cause fusing failures. Genuine Canon 137 toner is recommended for optimal performance.

Cuándo llamar a un técnico

If the error reappears after a full power cycle, the heating element or thermistor is likely damaged, requiring replacement by a technician.

Ficha técnica del equipo

  • Technology: Laser
  • Speed: 28 ppm
  • Connectivity: Wi-Fi & Ethernet
  • Consumables: Cartridge 137
  • Use Case: Home/Small Office
  • Official Canon support

Steps to follow

  1. 1

    Power off

    Turn off the printer and wait 5 minutes for the fuser to cool down.

  2. 2

    Unplug

    Remove the power cord from the wall outlet.

  3. 3

    Reboot

    Reconnect and power on after 1 minute of total disconnection.

Frequently asked questions

It is a temperature fault in the fuser unit that prevents proper toner fixing.

No, the E000 error locks printer functions for safety.

This printer uses the Canon 137 all-in-one cartridge.

Avoid overloading paper trays and use only standard grammage paper.

Error E000 Canon imageCLASS MF244dw: How to Fix | Vimazdev