e000imageCLASS D570i

Canon imageCLASS D570i Error E000: Troubleshooting Guide

The Canon imageCLASS D570i error E000 refers to a failure in the fuser assembly's heating mechanism. This error code appears when the thermal sensor detects that the fuser cannot reach its operational temperature. Why is my Canon imageCLASS D570i showing error E000? Most often, this is caused by a cold boot or a faulty heating lamp. We explain the diagnostic steps below.

1 views

Common causes

  • 1Defective fuser heating lamp.
  • 2Malfunctioning thermal sensor (thermistor).
  • 3Inadequate voltage supply from the power outlet.
  • 4Worn-out fuser sleeve or pressure roller.

Solutions

Diagnóstico rápido

The error E000 is typically confirmed when the printer panel displays the code immediately after power-on. Listen for clicking sounds from the fuser unit; if the printer stays in a loop, the heating element is likely compromised.

Solución paso a paso

  1. Disconnect the power cord from the electrical outlet.
  2. Wait 15 minutes to allow the fuser sensor to reset.
  3. Connect the printer directly to a wall outlet.
  4. Power on and observe if it initializes correctly.

Prevención y mantenimiento

Ensure optimal airflow around the back of the device. Use only high-quality Canon 137 toners to prevent fusing issues. Schedule annual cleaning sessions for the interior paper path.

Cuándo llamar a un técnico

If the power cycle fails, the fuser component has reached the end of its life and professional replacement is necessary.

Ficha técnica del equipo

  • Technology: Laser Monochrome
  • Speed: Up to 28 ppm
  • Connectivity: USB, Wi-Fi
  • Consumables: Canon 137 series
  • Recommendation: Small office environment
  • Drivers / firmware official

Steps to follow

  1. 1

    Power off

    Turn off the printer and unplug it for 15 minutes.

  2. 2

    Check ventilation

    Ensure rear cooling vents are free of dust.

  3. 3

    Restart

    Plug the unit directly into a wall outlet.

Frequently asked questions

This error means the fuser unit is not reaching the required operating temperature.

It is a critical system error that requires immediate inspection of the heating element.

The printer uses the Canon 137 toner cartridge series.

Keep the area clean and avoid using third-party fuser maintenance kits.