e-406fi-7130Cz

Fujitsu fi-7130Cz error E-406: Sensor failure

Fujitsu fi-7130Cz error E-406 occurs when the document feeder system sensors detect an inconsistency, preventing the motor from operating safely. This is typically caused by accumulated dust or paper particles blocking the sensors, confusing the system regarding document presence. Cleaning the scanner internals usually rectifies this error.

1 views

Common causes

  • 1Dust on optical paper sensors.
  • 2Paper fibers blocking sensor view.
  • 3Temporary electrical sensor fault.
  • 4Latch mechanism mechanical wear.

Solutions

Quick Diagnosis

If the scanner won't initiate paper loading and shows E-406, try gentle compressed air on the input tray sensors to clear unseen debris.

Step-by-Step Solution

  1. Disconnect and power off the scanner.
  2. Open the ADF compartment lid.
  3. Clean the optical sensors using compressed air or a soft brush.
  4. Check for any paper fibers sticking to sensor windows.
  5. Close the lid and reboot the device.

Prevention and Maintenance

Regular maintenance of feed paths is essential for the fi-7130Cz. Avoid scanning physically damaged or residue-prone documents.

When to Call a Technician

If the error persists after exhaustive cleaning, the sensor itself may have failed electrically and needs professional repair.

Equipment Technical Data

  • Technology: ADF scanner
  • Speed: 30 ppm / 60 ipm
  • Connectivity: USB 3.0
  • Consumable Kit: Roller kit (PA03670)
  • Recommended Use: Enterprise
  • Official Drivers / Firmware

Steps to follow

  1. 1

    Power off

    Switch off the unit to clear sensor states.

  2. 2

    Clean sensors

    Use compressed air to gently clean the sensor areas.

  3. 3

    Check feeder

    Ensure the ADF door is closed securely without blockages.

Frequently asked questions

Error E-406 indicates that internal feeder sensors are detecting an inconsistent state, often due to dirt or debris.

It usually happens when fine dust gets into the scanner mechanism after heavy use without cleaning.

The feed roller kit (PA03670) is the main consumable to replace to prevent feeder errors.

Perform monthly internal cleanings and avoid scanning documents that shed a lot of paper fibers.