e-202zc100xt

Zebra zc100xt E-202 Error: Ribbon Sensor Failure

The Zebra zc100xt error e-202 signals an issue with the printer's ribbon transport system. This error occurs when the printer fails to register the color panel markers or detects improper ribbon tension. Correcting the slack or replacing a broken ribbon will usually clear the error.

1 views

Common causes

  • 1Loose ribbon causing sensor timing issues.
  • 2Physical tear in the print ribbon.
  • 3Debris covering the color panel sensor.
  • 4Cartridge seated incorrectly in the printer.

Solutions

Diagnóstico rápido

The E-202 error is often triggered by sensor misreads if the ribbon is wrinkled or loose within the cartridge.

Solución paso a paso

  1. Open: Access the internal compartment.
  2. Check: Inspect the ribbon for breaks.
  3. Tension: Wind the knob to tighten the ribbon.
  4. Reset: Close and initialize.

Prevención y mantenimiento

Store ribbons in a controlled environment. High temperatures can cause ribbon material to soften, leading to tracking errors.

Cuándo llamar a un técnico

If re-tensioning doesn't solve the error, the internal ribbon motor or sensor assembly may require professional service.

Ficha técnica del equipo

  • Technology: Thermal transfer
  • Speed: 150 cards/hour
  • Connectivity: USB / Ethernet
  • Consumables: ZC Series Ribbon
  • Usage: ID Issuance
  • Drivers / firmware official

Steps to follow

  1. 1

    Open Cartridge

    Access the ribbon cartridge and remove it to inspect for breaks.

  2. 2

    Re-tension

    Use the tensioning knob to remove any slack from the ribbon.

  3. 3

    Reseat

    Reinsert the cartridge into the printer until it clicks into place.

Zebra zc100xt E-202 Error: Ribbon Sensor Failure | Vimazdev