e-08CM2200FDW

Pantum CM2200FDW error E-08: Sensor Fault

The Pantum CM2200FDW error E-08 is a maintenance notification concerning the output paper sensors. The printer stops operation because the sensor remains in an 'active' state, likely due to dust or a trapped piece of paper, even when the printer is actually clear.

1 views

Common causes

  • 1Dust on optical output sensor.
  • 2Small paper fragments blocking the flag.
  • 3Sensor lever (flag) physically stuck.
  • 4Failed sensor component.

Solutions

Quick Diagnosis

This error implies the exit sensor is blocked. If your tray is empty, investigate the exit path for debris.

Step-by-Step Solution

  1. Inspection: Open the rear door.
  2. Clear debris: Remove any stuck paper scraps.
  3. Air clean: Use compressed air on the sensor area.
  4. Power Cycle: Reset the printer to allow sensor calibration.

Prevention and Maintenance

Do not overload output trays. Heavy stacks can trigger sensor malfunctions and physical damage.

When to call a technician

If cleaning fails, the sensor flag is likely misaligned or broken, necessitating a professional repair.

Technical Data

  • Technology: Color Laser MFP
  • Performance: 24 ppm
  • Connectivity: Wi-Fi, Ethernet, USB
  • Feeder capacity: 250 sheets
  • Consumables: CTL-2000 series
  • Usage: Enterprise
  • Official Drivers / firmware

Steps to follow

  1. 1

    Inspect exit

    Check for paper scraps in the rear output area.

  2. 2

    Clean sensor

    Use compressed air to clean the sensor optic path.

  3. 3

    Test

    Run a test print to confirm the error is cleared.

Frequently asked questions

The exit paper sensor is detecting a persistent jam or is blocked by dust/debris.

It is a common maintenance issue usually solved by cleaning.

CTL-2000 series.

Only if deep cleaning does not resolve the error message.

Pantum CM2200FDW error E-08: Sensor Fault | Vimazdev