e-07-error-cuchillaFTP-343MCL

Fujitsu FTP-343MCL error E-07: Cutter Failure

The Fujitsu FTP-343MCL error E-07 warns that the automatic cutting blade has failed to complete its operation cycle. This commonly occurs when paper fragments are trapped in the mechanism or dirt buildup stiffens the cutting motion. Manual clearing and cleaning the area are usually enough to resume printing in point-of-sale environments.

0 views

Common causes

  • 1Paper obstructing the blade's travel path.
  • 2Debris buildup on the cutter rails.
  • 3Cutter motor sync failure.
  • 4Use of unauthorized adhesive labels.

Solutions

Quick Diagnosis

Error E-07 is a blade jam. Check the paper exit area for paper bits.

Step-by-Step Solution

  1. Disconnect the printer from the power source.
  2. Open the paper compartment and release the head lever.
  3. Carefully remove any paper debris obstructing the blade.
  4. Close everything and reconnect; the blade will automatically perform a position test.

Prevention and Maintenance

Use only good quality thermal paper and clean the cutting area with a dry cloth to remove residue.

When to call a technician

If the blade emits metallic noises and the error persists after cleaning, the cutting motor may be damaged.

Device Specs

  • Technology: Thermal printing.
  • Speed: High-speed line printing.
  • Connectivity: Serial/USB/Parallel.
  • Consumable: Thermal paper.
  • Link drivers: Download at official site

Steps to follow

  1. 1

    Open cover

    Release the lever to open the head.

  2. 2

    Clean debris

    Remove paper scraps from the cutter area.

  3. 3

    Reset

    Close the cover to allow automatic reset.

Frequently asked questions

It indicates the cutting blade is blocked by paper or dirt.

It may happen if using heavy paper or if adhesive buildup exists.

Use high-quality standard thermal paper.

Clean the cutter mechanism weekly using compressed air.