e-05fi-5016C

Fujitsu fi-5016C Scanner error e-05: Fix

The Fujitsu fi-5016C Scanner error e-05 indicates an overload in the feed motor preventing the ADF from functioning. This error occurs when the motor detects physical resistance beyond its normal operational parameters, often due to internal jams or worn rollers. Resolving this fault requires inspecting the paper path for physical obstructions.

0 views

Common causes

  • 1Excessive resistance due to non-visible paper jam.
  • 2Worn or residue-covered feed rollers.
  • 3Motor overheating from non-stop usage.
  • 4Electrical fault in the stepper motor controller.

Solutions

Diagnóstico rápido

If the scanner tries to start and stops showing E-05, there is an overload. Why does my Fujitsu scanner show error E-05? Usually due to overfilling or an internal jam that the motor cannot overcome.

Solución paso a paso

  1. Power off: Immediately disconnect the power to prevent motor burn-out.
  2. Inspection: Open the scanner and check for paper scraps preventing roller rotation.
  3. Cleaning: Remove any debris causing excessive friction.
  4. Test: Reconnect and power on; if the motor spins smoothly, the error should clear.

Prevención y mantenimiento

Respect the ADF's maximum page capacity. Clean rollers periodically with isopropyl alcohol to reduce the friction load required to feed paper.

Cuándo llamar a un técnico

If the motor emits strange noises and shows the E-05 again while empty, the motor component has failed mechanically and must be replaced.

Ficha técnica del equipo

  • Technology: ADF Scanner
  • Speed/Performance: 16 ppm
  • Connectivity: USB 2.0
  • Paper capacity: 50 sheets
  • Consumable: FI-5016C roller kit
  • Recommended use: Administrative offices
  • Official Drivers / Firmware

Steps to follow

  1. 1

    Disconnect

    Power off and unplug the scanner.

  2. 2

    Inspect

    Check for any paper scraps blocking the motor mechanism.

  3. 3

    Restart

    Plug in and power on after 1 minute.

Frequently asked questions

Error E-05 means the feed motor detects an overload or excessive resistance.

It can be serious if it points to an imminent failure of the internal motor.

Always use compatible roller kits to avoid unnecessary motor friction.

No, never lubricate the motor; it will ruin internal components.