e-03EcoTank L1250

Epson EcoTank L1250 error E-03: Paper Jam

The Epson EcoTank L1250 error E-03 is a physical jam warning that blocks the paper transport system. It is usually activated when a sheet deviates in the input tray or when the feed rollers are contaminated with dust, preventing the paper from advancing with proper traction. Resolving the Epson EcoTank L1250 error E-03 is simple, provided the removal steps are followed with care.

1 views

Common causes

  • 1Obstructed paper: Sheet loaded poorly that crumpled inside the system.
  • 2Dirty rollers: Accumulation of paper dust reducing grip.
  • 3Overloading: Tray overloaded preventing the first sheet from passing.
  • 4Unsuitable paper: Use of paper exceeding supported weight.

Solutions

Diagnostic

The E-03 error occurs when the printer locks after a failed loading attempt. Verify if there are torn paper scraps in the printhead area or the back of the tray.

Step-by-Step Solution

  1. Turn off printer: Always power down before handling the interior.
  2. Remove paper: Extract any sheet obstructing the path. Ensure all small fragments are removed.
  3. Clean roller: With a microfiber cloth dampened with distilled water, gently clean the black feed rollers.
  4. Verify alignment: Reload the paper, aligning side guides correctly against the stack edges.

Maintenance

Do not overload the tray (max 100 sheets). Avoid inserting paper with clips, staples, or post-its attached, as these can be sucked in and cause major damage.

When to call a technician

If the error persists after clearing the path, there may be a misaligned paper sensor or a faulty drive motor.

Technical Specs

  • Technology: Inkjet (EcoTank)
  • Capacity: 100 sheets (input)
  • Connectivity: Wi-Fi
  • Compatible Consumable: 544 series ink
  • Recommended Use: General documentation, home office
  • Official drivers / firmware

Steps to follow

  1. 1

    Turn off printer

    Turn off the unit to release motors and rollers.

  2. 2

    Remove paper

    Carefully pull the jammed sheet without tearing it.

  3. 3

    Clean roller

    Use a damp cloth to clean the feed rollers.

Frequently asked questions

This error occurs when the sensors detect that paper is not advancing correctly through the print path or a physical jam has occurred.

Never pull abruptly; this can misalign internal rollers or damage the paper sensor.

Use normal paper within permitted weights and avoid wrinkled or damp paper.

Perform a surface roller cleaning if you notice the printer starting to slip or grabbing multiple sheets at once.