e-0106fi-8170 Business Pro

Fujitsu fi-8170 Business Pro error E-0106: Troubleshooting

The Fujitsu fi-8170 Business Pro error E-0106 is a common notification that the unit's internal sensors have encountered an issue during document feed. This usually requires immediate cleaning of the paper path components. Why is my Fujitsu fi-8170 showing error E-0106? It most frequently happens due to paper dust buildup on the CIS sensors.

1 views

Common causes

  • 1Paper dust obstructing the optical path.
  • 2Worn-out separation pads.
  • 3Temporary hardware communication error.
  • 4Debris in the ADF feeding system.

Solutions

Quick Diagnosis

If the scanner stops working and the panel shows E-0106, it means the hardware cannot detect the paper presence correctly. Check for debris in the input tray to verify if the issue is a physical obstruction.

Step-by-step Solution

  1. Turn off the scanner and unplug the USB and power cables for 60 seconds.
  2. Open the upper cover and carefully remove any paper scraps or dust.
  3. Clean the feed rollers with an official cleaning cloth to ensure proper friction.
  4. Update the scanner firmware via PaperStream software to ensure optimal hardware communication.

Prevention and Maintenance

Perform a monthly deep cleaning of the paper path, especially in high-volume environments. Always use authorized maintenance kits to prevent excessive wear on the sensor arrays.

When to Call a Technician

If the error persists after cleaning and a hard power reset, internal components like the sensor board might require professional replacement.

Technical Data

  • Technology: Dual CIS
  • Performance: 70 ppm
  • Connectivity: USB 3.2 / LAN
  • Consumables: Roller Exchange Kit PA03810-0001
  • Usage: Professional
  • Official Drivers / Firmware

Steps to follow

  1. 1

    Power cycle

    Turn off the scanner and unplug the USB and power cables for 60 seconds.

  2. 2

    Roller cleaning

    Clean the feed rollers using an official cleaning cloth.

  3. 3

    Firmware update

    Update the scanner firmware via PaperStream software.

Frequently asked questions

This error typically points to a paper jam or a sensor blockage within the document feeding path.

It is a functional error that stops the scan, but it is usually resolved through basic maintenance.

It uses standard roller exchange kits specifically designed for the fi-8000 series.

Regular monthly cleaning of the rollers and sensor area prevents document feed faults.