e-010MC160n

OKI MC160n error E-010: Troubleshooting Guide

The OKI MC160n error E-010 signifies a network connectivity issue regarding the internal interface. It arises when the printer fails to negotiate a link with local network hardware. Addressing both physical cabling and internal IP settings is usually required.

1 views

Common causes

  • 1Physical port damage.
  • 2Poor quality cables.
  • 3IP address conflict.
  • 4Network firmware failure.

Solutions

Diagnóstico rápido

If the Ethernet LEDs aren't active, the connection is down. E-010 confirms an handshake failure.

Solución paso a paso

  1. Check cabling: Replace the Ethernet cable with a verified one.
  2. Power cycle: Reset the printer and the local network router.
  3. Verify IP: Ensure the static or DHCP IP is correct.
  4. Test: Use ping command to check response.

Prevención y mantenimiento

Use static IP addresses to minimize conflicts. Ensure high-quality shielded cables. Keep network port free of dust.

Cuándo llamar a un técnico

If E-010 remains after cabling/router tests, the internal network module might require repair.

Ficha técnica del equipo

  • Technology: LED Digital
  • Consumables: MC160n Toner Series
  • Connectivity: USB, Ethernet
  • Usage: Office
  • Official drivers

Steps to follow

  1. 1

    Check

    Inspect Ethernet cable.

  2. 2

    Reset

    Power cycle router and printer.

  3. 3

    IP

    Check for IP conflicts.

Frequently asked questions

Internal network card failed to handshake.

Not necessarily, restart network first.

Genuine MC160n series.

Use static IP.