e-01SP 100SF

Ricoh SP 100SF error E-01: Troubleshooting

The Ricoh SP 100SF error E-01 is the most frequent paper jam warning on this model. It occurs when the document deviates in the input tray or stops before reaching the fuser. If you are asking why does my Ricoh SP 100SF show error E-01, it is likely that the paper guides are too loose or the paper is damp.

1 views

Common causes

  • 1Improper paper loading in the input tray.
  • 2Damp or overly textured paper.
  • 3Dirty feed roller from prolonged use.
  • 4Small obstruction in the feed sensor.

Solutions

Quick Diagnosis

Error E-01 appears on the control panel after a failed printing attempt. Inspect the feed area visually.

Step-by-Step Solution

  1. Turn off the printer to avoid damage.
  2. Open the front door for access.
  3. Pull out the toner cartridge to check the paper path.
  4. Pull the jammed paper gently (do not pull hard).
  5. Reinstall the toner and turn on the device.

Prevention and Maintenance

Do not fill the tray above the indicated level. Keep paper in a dry, flat area.

When to Call a Technician

If the error persists after clearing all paper, the presence sensor may be blocked by a small torn fragment.

Device Technical Specifications

  • Technology: Monochrome Laser
  • Speed: 13 ppm
  • Connectivity: USB 2.0
  • Compatible Consumable: Ricoh SP 100 All-in-One
  • Recommended Use: Home
  • Official Drivers / Firmware

Steps to follow

  1. 1

    Open

    Open the front cover to access the toner.

  2. 2

    Extract

    Remove the toner and take out the jammed paper carefully.

  3. 3

    Close

    Reinsert the cartridge and close the cover properly.

Frequently asked questions

The E-01 indicates that paper is jammed in the feed path.

Align paper well in the tray and do not overload.

Uses the SP 100 All-in-One cartridge.

Use a dry cloth if there are visible paper scraps.

Ricoh SP 100SF error E-01: Troubleshooting | Vimazdev