e-0006ECOSYS P2135dn

Kyocera ECOSYS P2135dn error E-0006: Fix Guide

The Kyocera ECOSYS P2135dn error E-0006 indicates a signal failure between the printer's controller and the imaging drum unit. This prevents the machine from initiating a print sequence. To resolve the Kyocera ECOSYS P2135dn error E-0006, ensuring the unit is correctly seated and contacts are clean is essential.

1 views

Common causes

  • 1Dirty contacts: Toner powder insulating electrical pins.
  • 2Loose connection: Drum not fully locked in position.
  • 3Sensor fault: Imaging unit sensor failing.
  • 4Electronic chip error: Drum unit chip is damaged.

Solutions

Quick Diagnosis

The error E-0006 pops up during the self-test sequence. If the drum unit was handled recently, it is likely a connection issue.

Step-by-step Solution

  1. Power Off: Safely shut down the printer.
  2. Remove Drum: Pull the imaging drum unit carefully out.
  3. Clean Contact Pins: Use isopropyl alcohol on a swab to wipe the connection points.
  4. Reinsert: Push the unit firmly back until a 'click' is heard.

Prevention and Maintenance

Keep the printer clean from toner dust. Using original TK-170 cartridges prevents internal debris build-up.

When to Call a Technician

If the error doesn't clear, the logic board communication port may be faulty and requires professional diagnostics.

Equipment Technical Data

  • Technology: Laser.
  • Speed: 35 ppm.
  • Connectivity: Ethernet/USB.
  • Consumable: TK-170 Toner.
  • Recommended Use: Enterprise.
  • Official Drivers

Frequently asked questions

It is a communication fault between the logic board and the drum unit assembly.

Reseating the drum often cleans the contacts and clears the error.

It uses TK-170 cartridges.

Yes, maintenance counters must be reset after replacing the drum unit.