Drum End SoonDCP-L3560CDW

Fix Brother Drum End Soon Error: DCP-L3560CDW Guide

The 'Drum End Soon' message on the Brother DCP-L3560CDW is a preventive notification indicating that the drum unit is nearing the end of its specified life. It does not stop printing immediately, but warns that image quality will likely degrade soon. The recommended solution is to plan for a new drum unit (DR-248CL) and reset the counter via the printer menu after installation.

1 views

Common causes

  • 1Internal page counter reaching the programmed service life threshold.
  • 2Natural wear of the drum's photosensitive cylinder surface.
  • 3Toner residue buildup that the internal wiper blade fails to remove.
  • 4Physical damage to the drum from debris or foreign objects.

Solutions

Diagnóstico rápido

The error appears when the drum page counter nears the 18,000-20,000 page limit. Check if printouts show vertical streaks or repeating spots on the sides; these are clear signs that the drum unit has exceeded its lifespan and needs replacement to avoid damaging other components.

Solución paso a paso

  1. Purchase a genuine or certified compatible DR-248CL drum unit for optimal compatibility.
  2. Open the front cover, pull out the drum unit and toner assembly, and detach the toner cartridge from the old unit.
  3. Clean the corona wire by sliding the green tab across the top several times before installing the toner cartridge into the new drum unit.
  4. Reset the counter via the LCD menu: Settings > Equipment Info > Life Remaining > Drum, and confirm the replacement.

Prevención y mantenimiento

Avoid touching the shiny surface of the drum with your fingers; skin oils cause permanent spots on printouts. Perform a corona wire cleaning monthly to maintain crisp text. Avoid using low-quality refilled toners, as they often deposit residue that ruins the drum surface.

Cuándo llamar a un técnico

If the message persists after replacing the drum and resetting the counter, or if you hear metallic noises, there may be an internal sensor fault. A technician should inspect the control board to ensure the counter reset was successful.

Ficha técnica del equipo

  • Drum type: DR-248CL Drum Unit
  • Estimated life: ~18,000 - 20,000 pages
  • Consumibles: TN-248 Toner (CMYK)
  • Imaging technology: Color Laser, 4 drums
  • Critical maintenance: Monthly corona wire cleaning
  • Official drivers / firmware

Steps to follow

  1. 1

    Procure replacement drum

    Obtain the DR-248CL drum unit to ensure original quality standards.

  2. 2

    Install hardware

    Place the toner cartridges into the new drum housing carefully.

  3. 3

    Clean corona wire

    Slide the green tab several times to clear the cleaning mechanism.

  4. 4

    Manual counter reset

    Use the printer's LCD menu to confirm the new drum installation and reset the cycle.

Frequently asked questions

Yes, it is only a warning. You can continue printing until the quality drops, but replacing it soon is recommended.

If you don't reset it, the printer will keep displaying the warning and may eventually stop printing, assuming the drum is exhausted.

Only the Brother DR-248CL drum unit is compatible with this model.

Look for vertical streaks, repeating marks, or grey backgrounding on white pages. These are clear symptoms of a worn drum.

Fix Brother Drum End Soon Error: DCP-L3560CDW Guide | Vimazdev