drum-endhl-2270dw

Brother HL-2270DW error drum-end: Fix Guide

The Brother HL-2270DW error drum-end signals that the internal counter for the DR-420 drum unit has reached its programmed limit. While the error prompts replacement, it can often be reset to extend service life if your prints remain free of defects.

1 views

Common causes

  • 1Page counter limit reached.
  • 2Surface wear on photosensitive cylinder.
  • 3Corona wire debris buildup.
  • 4Drum sensor read failure.

Solutions

Quick Diagnosis

The 'Drum' LED flashes, indicating a software limit has been reached. If print quality is still clear, the drum is likely still functional.

Step-by-step Solution

  1. With the printer on, open the front cover.
  2. Press and hold the 'Go' button until all LEDs light up.
  3. Release the button and close the front cover.
  4. The drum counter will reset.

Prevention and Maintenance

Clean the corona wire regularly by sliding the green tab. Use genuine TN-450 toner to prevent unnecessary drum wear.

When to Call a Technician

If horizontal lines or repeating spots persist after a reset, the drum surface is damaged and must be replaced.

Equipment Specs

Brother HL-2270DW error drum-end: Fix Guide | Vimazdev