Cover is OpenBrother MFC-J995DW

Fix 'Cover is Open' Error on Brother MFC-J995DW

The 'Cover is Open' message appears when the Brother MFC-J995DW system detects that the cartridge access door or the scanner lid is not properly closed. While often a minor issue, it might indicate a blocked or faulty sensor preventing the print mechanism from starting. This guide will help you verify if the problem is a physical latch or an electronic sensor fault.

1 views

Common causes

  • 1The lid is not making full contact with the safety sensor.
  • 2Foreign object blocking the latch mechanism.
  • 3Worn-out cover sensor due to regular use.

Solutions

Obstruction Check

  1. Firmly open and close all printer lids.
  2. Ensure no small debris or paper scraps are caught in the latch.
  3. Check that cartridges are fully seated in their slots.

Sensor Reset

  1. Leave the cover open while the printer is powered on.
  2. Gently manipulate the sensor switch if accessible.
  3. Monitor the LCD screen to see if the error status updates.

Steps to follow

  1. 1

    Physical Inspection

    Check every access door and cover of the machine.

  2. 2

    Cleaning Latches

    Remove any obstructions near the locking tabs.

  3. 3

    Screen Verification

    Verify the error clears upon locking the lid securely.

Frequently asked questions

The cover sensor might be dirty or slightly misaligned, preventing the printer from recognizing that it is closed.

The printer will not initiate any print or scan job until the sensor registers the closed state for safety reasons.

It is not recommended to bypass internal safety sensors as it can interfere with proper printer operation.

Fix 'Cover is Open' Error on Brother MFC-J995DW | Vimazdev