C450e-STUDIO 330ACHas video

How to Fix Toshiba e-STUDIO 330AC Error C450

The C450 error code on the Toshiba e-STUDIO 330AC signifies a fuser unit warming-up error or thermistor temperature anomaly. This triggers a hardware safety lock to prevent overheating.

0 views

Common causes

  • 1Toner dust buildup insulating the fuser thermistor from accurate contact.
  • 2Blown thermal cut-out switch (thermostat) causing open circuit.
  • 3Fuser heating lamp failure.
  • 4AC power line voltage instability.

Solutions

Diagnostic and Recovery Procedure

The C450 fault lock remains active even after resolving physical hardware problems. Follow these standard technical procedures to clear it:

  1. Hardware Assessment:
    * Power off and unplug the copier. Let it sit for 20 minutes to prevent thermal injury.
    * Slide out the fuser unit. Carefully clean any toner debris or build-up on the thermistors.
    * Measure fuser lamp resistance to confirm continuity.
  1. Software Lock Reset (08 Service Mode):
    * Turn on the machine while pressing and holding both the 0 and 8 keys.
    * When the test screen is displayed, release the keys.
    * Input service code 2002 and press 'Start'.
    * Update the register value to 0.
    * Press 'OK' or 'Set' to save modifications, then power cycle the printer normal.

Steps to follow

  1. 1

    Shut down and cool down

    Power off the printer and pull out the mains cable to allow internal heaters to cool before service.

  2. 2

    Inspect thermistors

    Gently check and clean surface deposits from thermistors using isopropyl alcohol.

  3. 3

    Perform 08 system reset

    Boot with keys 0 and 8 held down, go to status address 2002, and set the value to 0.

Videos

Frequently asked questions

No, because C450 represents a potential fire hazard flag. It requires entering 08 service mode to manually set status parameter 2002 back to zero.

How to Fix Toshiba e-STUDIO 330AC Error C450 | Vimazdev