c3300FS-1370D

Kyocera FS-1370D Error C3300: Technical Solution

The Kyocera FS-1370D error C3300 indicates a fault in the cooling fan motor. The main board triggers this error when the expected rotation speed of the fan is not met, activating a safety mode to prevent thermal damage. Resolution involves physical cleaning or replacing the cooling assembly.

1 views

Common causes

  • 1Excessive dust clogging the fan motor.
  • 2Debris blocking fan blades.
  • 3Motor electronic fault.
  • 4Bearing wear due to long service time.

Solutions

Diagnóstico rápido

If you hear a stuttering noise at startup or feel no airflow from the rear vents, the fan motor is likely obstructed or dead.

Solución paso a paso

  1. Power down: Turn off the device completely.
  2. External cleaning: Use compressed air to blow out dust from ventilation vents.
  3. Manual check: Ensure no labels or external obstructions are blocking the fan blades.
  4. Power cycle: Allow for cooling and restart.

Prevención y mantenimiento

Dust is the primary threat to this machine. Perform annual internal cleaning and maintain proper clearance from walls for exhaust heat.

Cuándo llamar a un técnico

If the fan is clear and the C3300 error persists, the motor has failed and must be replaced professionally.

Ficha técnica del equipo

  • Technology: Monochrome laser printer
  • Speed: 35 ppm
  • Connectivity: USB, Ethernet
  • Capacity: 250-sheet standard tray
  • Compatible Consumables: Genuine Kyocera TK-170 toner
  • Target use: Small office / workgroups
  • Drivers / official firmware

Steps to follow

  1. 1

    Check ventilation

    Turn off the printer and check if the rear fan spins freely without obstruction.

  2. 2

    System reset

    Unplug the device for 5 minutes to reset the fan speed monitoring sensor.

  3. 3

    Startup test

    Power on and watch if the fan starts spinning during the warm-up cycle.

Frequently asked questions

It indicates a main fan motor error; the printer detects it is not rotating at the required speed.

No, if the fan isn't working, the equipment can overheat and suffer permanent internal damage.

Use original Kyocera TK-170 toner to prevent internal dust buildup that clogs fans.

Keep the printer away from walls to allow airflow and clean with compressed air every 6 months.