c3103TASKalfa Pro 55000c

Kyocera TASKalfa Pro 55000c error C3103: Output Fault

The Kyocera TASKalfa Pro 55000c error C3103 signals an issue within the output transport assembly. This is often caused by the paper not clearing the final sensor within the expected timeframe, which is common during high-speed production cycles.

0 views

Common causes

  • 1Physical paper jam in the finisher unit.
  • 2Output sensor obscured by debris.
  • 3Failure of the exit path drive motor.
  • 4Media misalignment into the finisher.

Solutions

Diagnóstico rápido

If the machine displays C3103, paper is stuck in the finisher section. Check for any unusual grinding sounds from motors that might indicate an active blockage.

Solución paso a paso

  1. Access the finishing unit doors.
  2. Clear out any jammed sheets or scraps.
  3. Clean the path sensors using compressed air.
  4. Close doors and verify machine status.

Prevención y mantenimiento

Weekly sensor cleaning is highly recommended. Ensure paper media meets specifications to prevent dust release during high-speed printing.

Cuándo llamar a un técnico

If the transport rollers are idle while the print engine is running, the drive motor or the finisher control board needs technical attention.

Ficha técnica del equipo

  • Technology: Production Inkjet
  • Speed: High production
  • Connectivity: Advanced network interfaces
  • Capacity: High-volume finisher unit
  • Compatible consumables: TASKalfa Pro 55000c Series
  • Recommended use: Industrial printing environments
  • Official drivers / firmware

Steps to follow

  1. 1

    Tray inspection

    Open finisher access doors and remove any paper sheets blocking the output sensor area.

  2. 2

    Sensor check

    Clear all paper paths of dust or paper debris using a dry compressed air blower.

  3. 3

    System reset

    Power down the unit, wait a few seconds, then power back on to retry transport.

Frequently asked questions

It indicates a transport error in the finisher unit, where the paper failed to reach or pass the final sensor.

If there are no physical jams and the error repeats, it points to a sensor calibration issue or a failed output motor.

Always use original Kyocera inks to prevent transport issues related to paper weight inconsistencies.

Always adjust input tray side guides to perfectly fit your paper format for smooth transitions.