c0050bizhub 195
Konica Minolta bizhub 195 error C0050: Fix Guide
The Konica Minolta bizhub 195 error C0050 indicates a failure in the tray's paper lift mechanism. If the paper platform cannot rise to meet the feed rollers, the system reports this code. This is usually caused by physical obstructions, overloading, or wear in the motor mechanism.
1 views
Common causes
- 1Overloaded paper tray.
- 2Worn lift gear assembly.
- 3Lift motor failure.
- 4'Tray up' position sensor fault.
Solutions
Quick Diagnosis
The error C0050 occurs during boot-up. If you hear rhythmic clicking when the tray is pushed in, the motor is failing to engage with the lift plate.Step-by-Step Solution
- Tray Removal: Pull the tray out fully.
- Check Lift Plate: Verify the plate moves freely by hand.
- Test Motor: Power on without the tray to hear if the internal motor attempts to turn.
- Reset: Restart to re-sync mechanical positioning.
Prevention and Maintenance
Do not overfill the paper tray. Regular cleaning of the internal tray cavity prevents debris buildup which can stall the gears.When to call a technician
If the platform doesn't rise or the grinding persists, the lift motor or its drive gear assembly likely needs technical replacement.Technical Data
- Technology: Monochrome Laser
- Performance: 19 ppm
- Connectivity: USB 2.0
- Feeder capacity: 250 sheets
- Consumables: TN-116 / TN-117 toner
- Usage: Small Office
- Official Drivers / firmware
Steps to follow
- 1
Remove tray
Take out the paper tray and inspect for mechanical locks.
- 2
Reboot
Power cycle to recalibrate the lift motor.
- 3
Gear inspection
Look for visible damage on the tray lift gears.
Frequently asked questions
It indicates a failure in the paper lift motor that feeds sheets to the rollers.
Try clearing jams first; motor replacement is only for unresponsive units.
Uses TN-116/TN-117 toner.
Do not exceed the paper capacity limit in the tray.