Error C0010 Kyocera TASKalfa 1802i: Quick Fix Guide
The Kyocera TASKalfa 1802i error c0010 occurs when the control system detects a failure in the main motor rotation. This issue often stems from mechanical obstructions in the rollers or a misalignment in the developing unit. To solve this c0010 error on the TASKalfa 1802i, perform an inspection for paper jams and execute a power cycle.
Common causes
- 1Paper jam in the fuser area.
- 2Wear on main motor gears.
- 3Rotation sensor blocked by toner dust.
- 4Power supply failure limiting required torque.
Solutions
Diagnóstico rápido
The error c0010 shows up when the unit becomes inoperative immediately after startup. If you hear grinding noises, a foreign object is likely blocking the motor.Solución paso a paso
- Power cycle: Unplug the machine from power for 60 seconds.
- Clear obstructions: Open side covers and remove any paper debris.
- Restart: Turn on the unit and check if the error is cleared.
Prevención y mantenimiento
Clean rollers with isopropyl alcohol every 5,000 prints. Using low-quality paper increases jam probability. Use genuine TK-4105 toner.Cuándo llamar a un técnico
If the message persists after rebooting, internal motor or motherboard failure may be present, requiring professional service.Ficha técnica del equipo
- Technology: Monochrome laser
- Print Speed: 18 ppm
- Connectivity: USB 2.0
- Paper Capacity: 400 sheets
- Compatible Consumable: TK-4105
- Recommended Use: Small office
- Official drivers / firmware
Steps to follow
- 1
Power cycle
Unplug the machine from power for 60 seconds.
- 2
Clear obstructions
Open side covers and remove any paper debris.
- 3
Restart
Turn on the unit and check if the error is cleared.
Frequently asked questions
This error points to a main motor blockage usually caused by internal mechanical obstructions.
It is a system error that stops operation until the mechanical obstacle is cleared.
Use genuine TK-4105 toner to prevent system overload.
Regularly clean the pickup rollers and keep the device dust-free.