c-6050bizhub C3120i

Konica Minolta bizhub C3120i Error C-6050: Lamp Fault

The Konica Minolta bizhub C3120i error C-6050 warns of a failure in the fuser lamp. It indicates the temperature has not reached operational levels or remains unstable, preventing proper toner bonding. To fix the Konica Minolta bizhub C3120i error C-6050, you must perform a thermal reset or contact support if the lamp has reached end of life.

1 views

Common causes

  • 1Fuser lamp filament burnout.
  • 2Thermistor disconnected or giving false readings.
  • 3Sudden input voltage fluctuations.
  • 4Buildup of residue on the pressure roller.

Solutions

Quick Diagnosis

The error C-6050 typically occurs right after power-up. If the unit struggles to heat and then throws the error after a minute, the issue is an internal lamp fault.

Step-by-step Solution

  1. Cooling: Unplug the printer for at least 30 minutes.
  2. Stabilization: Ensure the wall outlet provides stable voltage.
  3. Testing: Plug the device directly into the wall, not a power strip.
  4. Diagnosis: If the error persists, the fuser unit must be replaced.

Prevention and Maintenance

Always use surge protection. Power fluctuations are the leading cause of premature fuser lamp failure.

When to Call a Technician

Fuser lamp replacement requires printer disassembly and high-temperature handling; this must be left to a technician.

Technical Specifications

  • Technology: bizhub Color Laser
  • Speed: 31 ppm
  • Connectivity: LAN / USB / Wi-Fi
  • Consumable: C3120i Series Cartridges
  • Recommended Use: Home and Office
  • Official Drivers / firmware

Steps to follow

  1. 1

    Restart

    Turn off and unplug the device for 30 minutes.

  2. 2

    Check Power

    Verify the power cable is securely connected.

  3. 3

    Call Support

    If the error persists, the fuser lamp is defective.

Frequently asked questions

It is a thermal fault where the fuser lamp does not reach the required temperature within the timeout limit.

A long reset helps reset sensors, but if the component failed physically, the error will recur.

The complete fuser unit is the component responsible for heating.

Avoid overloading the printer with continuous print runs without pauses.

Konica Minolta bizhub C3120i Error C-6050: Lamp Fault | Vimazdev