c-2559bizhub C3320i

Konica Minolta bizhub C3320i C-2559 error: Fix

The Konica Minolta bizhub C3320i C-2559 error arises when the controller detects an abnormal rotation speed from the development motor. This error is critical for image formation and triggers a system lockout to prevent catastrophic mechanical failure. Professional diagnostic tools are usually required to clear this error.

1 views

Common causes

  • 1Development motor hardware failure.
  • 2Heavy load due to compacted toner or developer.
  • 3Disconnected motor harness.
  • 4Seized bearings within the imaging unit assembly.

Solutions

Diagnóstico rápido

The C-2559 error halts all operations on your bizhub C3320i. If you hear grinding sounds when attempting to print, the issue is likely mechanical interference in the development drive assembly.

Solución paso a paso

  1. Reboot: Shut down and unplug the device.
  2. Visual Inspection: Check the imaging unit for jammed toner or debris that might lock the gears.
  3. Technical Test: A technician must measure motor voltage and check for excessive gear torque.
  4. Reset: The code requires a factory reset via service mode after verifying the drive motor condition.

Prevención y mantenimiento

Schedule service inspections every 60,000 prints to check for drive gear wear. Only use genuine toner to keep developer viscosity within specs.

Cuándo llamar a un técnico

The C-2559 is a complex mechanical error. If the reboot doesn't resolve it, hardware replacement of the development motor or image unit is likely necessary.

Ficha técnica del equipo

  • Technology: Color Laser Multifunction
  • Speed: 33 ppm
  • Connectivity: USB, Gigabit Ethernet, Wi-Fi
  • Compatible supply: TNP-79 Toner family
  • Intended use: Corporate environments
  • Official drivers / firmware

Frequently asked questions

This code indicates an abnormal rotation or failure of the development motor, disrupting toner distribution.

Yes, avoid forcing the machine, as C-2559 can cause damage to the imaging unit gears.

Original supplies are highly recommended for bizhub units to ensure proper developer viscosity and motor torque.

Professional maintenance is recommended every 60,000 impressions to keep transmission systems and imaging units clean.