c-0510bizhub 200

Konica Minolta bizhub 200 Error C-0510: Fix

The Konica Minolta bizhub 200 error C-0510 refers to a drive motor fault in the paper transport system. This error occurs when the internal sensors detect excessive resistance while the machine tries to feed paper. Resolving the C-0510 error on the Konica Minolta bizhub 200 is typically done by removing physical obstructions.

1 views

Common causes

  • 1Stuck gears in the transport assembly.
  • 2Overloaded transport motor.
  • 3Blocked paper sensors.
  • 4Electrical failure in motor drivers.

Solutions

Quick Diagnostics

The C-0510 error shuts down the machine to prevent motor burnout. Listen for grinding noises when starting; they point to jammed gears.

Step-by-Step Solution

  1. Power Down: Disconnect from the main power source.
  2. Debris Removal: Inspect all internal pathways for clips, torn paper, or obstructions.
  3. Manual Rollers: Rotate the drive rollers gently to ensure they are not seized.
  4. Restart: Power on to re-sync the motors.

Prevention and Maintenance

Keep the paper path clean and ensure the paper guides are not set too tight. Annual professional lubrication is recommended.

When to Call a Technician

If mechanical resistance remains after cleaning, the motor may need professional repair or replacement.

Device Technical Specifications

  • Technology: Laser
  • Speed: 20 ppm
  • Connectivity: LAN
  • Capacity: 1350 sheets
  • Consumable: TN-211
  • Use: Office
  • Support

Steps to follow

  1. 1

    Mechanical Reset

    Power off and disconnect. Check that all rollers spin freely.

  2. 2

    Sensor Inspection

    Use compressed air to clean paper path sensors.

  3. 3

    Restart

    Power on to allow system self-test.

Frequently asked questions

The C-0510 points to an overcurrent or blockage in the main transport motor.

Not necessarily; usually just a mechanical blockage.

Uses TN-211.

Clean rollers and avoid heavy cardstock.

Konica Minolta bizhub 200 Error C-0510: Fix | Vimazdev