c-0210bizhub 208

Fix Konica Minolta bizhub 208 error C-0210: Tray Issues

The Konica Minolta bizhub 208 error C-0210 is a common alert indicating a communication issue between the printer and the paper feed tray. If you are wondering why is my Konica Minolta bizhub 208 showing error C-0210, it is often due to a tray misalignment or a faulty sensor signal. This guide provides the necessary steps to restore your printer's tray functionality.

0 views

Common causes

  • 1Misaligned paper guides triggering tray sensor errors.
  • 2Debris blocking the rear of the paper tray.
  • 3Sensor contact failure at the tray insertion point.
  • 4Wear on the tray lift drive mechanism.

Solutions

Quick Diagnosis

This error occurs when the printer cannot properly acknowledge the tray unit. Confirm if the display specifies which tray is causing the fault.

Step-by-Step Solution

  1. Remove Tray: Pull out the tray fully to inspect for obstructions.
  2. Align Guides: Reset the side guides firmly against the paper edges.
  3. Clean Sensors: Wipe the internal tray sensor area with a lint-free cloth.
  4. Power Cycle: Turn the machine off and on to reset the firmware detection.

Prevention and Maintenance

Use correct paper sizes and ensure the guides are not overtightened. Clean the feed rollers every 50,000 copies to prevent paper debris accumulation.

When to Call a Technician

If the tray remains undetected after manual adjustments, the internal sensor or main drive motor for the tray lift may have failed.

Equipment Data Sheet

  • Technology: Laser Digital Copier
  • Speed: 20 ppm
  • Capacity: 250 sheets
  • Compatible Toner: TN-118
  • Use Case: Small office printing
  • Official Drivers / Firmware

Steps to follow

  1. 1

    Remove Tray

    Fully pull out the main paper tray.

  2. 2

    Check Guides

    Verify side guides are set to the paper size.

  3. 3

    Reboot

    Close the tray and power cycle the unit.

Frequently asked questions

The error usually stems from the machine failing to detect the tray's position or closure status.

Yes, as the machine cannot feed paper until the tray is correctly recognized.

The bizhub 208 uses the TN-118 toner cartridge.

Yes, periodic cleaning of the feed rollers prevents sensor errors.